2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit provides power to operate the blind spot monitor sensor.

WIRING DIAGRAM

E244551E18

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH, BLIND SPOT MONITOR SENSOR RH - BATTERY AND BODY GROUND)

  1. E283775E04
    Disconnect the blind spot monitor sensor LH connector.

  1. Disconnect the blind spot monitor sensor RH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R42-5 (BLB) - Body ground
    Engine switch on (IG)
    11 to 14 V
    R42-5 (BLB) - Body ground
    Engine switch off
    Below 1 V
    R43-5 (BRB) - Body ground
    Engine switch on (IG)
    11 to 14 V
    R43-5 (BRB) - Body ground
    Engine switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R42-10 (BLGD) - Body ground
    Always
    Below 1 Ω
    R43-10 (BRGD) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Blind Spot Monitor Sensor LH)
*b
Front view of wire harness connector
(to Blind Spot Monitor Sensor RH)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Power Source Circuit (Aug 2013 – Jul 2014)COMPONENTS (from Aug 2013) →