2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

U1331 Software Incompatibility with Body Control Module "B"

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.
DTC Code
DTC Detection Condition
Trouble Area
U1331
Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match.
  1. Main body ECU (multiplex network body ECU)
  2. Blind spot monitor sensor LH
  3. Blind spot monitor sensor RH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CONFIRM PART NUMBER (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])
  1. Check the main body ECU (multiplex network body ECU) part number.

    1. Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.

      OK:
      The part number is correct.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
OK


2. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor sensor LH (master)
    B
    DTC is output from the blind spot monitor sensor RH (slave)
    C



B
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← U0232 Lost Communication with Blind Spot Monitor Slave Module (from Aug 2014)U1331 Software Incompatibility with Body Control Module "B" (from Aug 2014) →