2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1A45 Vehicle Speed Sensor

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (master cylinder solenoid) via CAN communication.
DTC Code
DTC Detection Condition
Trouble Area
C1A45
A fail flag is transmitted from the skid control ECU (master cylinder solenoid).
  1. Vehicle stability control system
  2. Blind spot monitor sensor LH
  3. Blind spot monitor sensor RH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for vehicle stability control system DTCs (Click here).

    OK:
    Vehicle stability control system DTCs are not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    Result 
    Result
    Proceed to
    No DTC is output
    A
    DTC is output from the blind spot monitor sensor LH (master)
    B
    DTC is output from the blind spot monitor sensor RH (slave)
    C



B
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2014)C1A45 Vehicle Speed Sensor (from Aug 2014) →