2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

C1AB0 Short to +B in Outer Mirror Indicator(Master)

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects a +B short in the blind spot monitor indicator LH.
DTC Code
DTC Detection Condition
Trouble Area
C1AB0
With the blind spot monitor main switch assembly (multi-function switch) on, the voltage applied to the indicator is high for a certain amount of time even though the blind spot monitor sensor is not outputting voltage to the indicator.
  1. Harness or connector
  2. Blind spot monitor sensor LH
  3. Outer rear view mirror assembly LH
  4. Outer rear view mirror sub-assembly LH

WIRING DIAGRAM

E221720E12

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.


1. CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (OUTER REAR VIEW MIRROR INDICATOR LH CIRCUIT)
  1. Disconnect the R42 blind spot monitor sensor LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R42-4 (OMIL) - Body ground
    Engine switch on (IG)
    Below 1 V



NG
Go to step 3
OK

REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)

3. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - OUTER REAR VIEW MIRROR ASSEMBLY LH)
  1. Disconnect the R42 blind spot monitor sensor LH connector.

  1. Disconnect the K2 outer rear view mirror assembly LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R42-4 (OMIL) - Body ground
    Engine switch on (IG)
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH)
  1. Disconnect the R42 blind spot monitor sensor LH connector.

  1. Disconnect the outer rear view mirror sub-assembly LH connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R42-4 (OMIL) - Body ground
    Engine switch on (IG)
    Below 1 V



NG
REPLACE OUTER REAR VIEW MIRROR ASSEMBLY LH (Click here)
OK

REPLACE OUTER REAR VIEW MIRROR SUB-ASSEMBLY LH (Click here)


← C1AB0 Short to +B in Outer Mirror Indicator(Master) (Aug 2013 – Jul 2014)C1AB1 Short to +B in Outer Mirror Indicator(Slave) (Aug 2013 – Jul 2014) →