C1AC2 Slave Module Horizontal Axis Misalignment
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.- HINT:
- If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch assembly (multi-function switch) on, the blind spot monitor system may store this DTC by mistake.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1AC2 |
When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated. |
Blind spot monitor sensor RH |
INSPECTION PROCEDURE
- NOTICE:
- When checking for DTCs, make sure that the blind spot monitor main switch assembly (multi-function switch) is on.
| 1. CHECK INSTALLATION CONDITION |
Check the installation condition of the blind spot monitor sensor RH (Click here).
- HINT:
- Take the appropriate action in accordance with the result.
| NEXT | |
| 2. PERFORM BEAM AXIS CONFIRMATION |
Install the rear bumper (Click here).
Perform Blind Spot Monitor Beam Axis Confirmation using the GTS (Click here).
- OK:
- Blind Spot Monitor Beam Axis Confirmation performs normally.
|
|
||||
| OK | ||
| ||
