CUSTOMIZE PARAMETERS
Removal / installation · Vehicles built from Aug 2013
| 1. REMOVE CUSTOMIZE SEAT BELT WARNING SYSTEM |
- NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Record the current settings before customizing.
- When the customer requests a change in a function, first make sure that the function can be customized.
Customizing with the intelligent tester
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Utility / Customize Setting.
Select the setting by referring to the table below.
Seat Belt Warning Display
Default
Contents
Setting
Driver Side Seatbelt Warning Buzzer
ON
If the driver side seat belt is unfastened and the vehicle is driven at approximately 20 km/h (12.5 mph) or more, the system sounds the seat belt warning buzzer.
ON or OFF
Front Passenger Side Seatbelt Warning Buzzer
ON
If the front passenger side seat belt is unfastened with the front passenger seat occupied and the vehicle is driven at approximately 20 km/h (12.5 mph) or more, the system sounds the seat belt warning buzzer.
ON or OFF
