2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

B158F AV Signal Stoppage (Low Battery Voltage)

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily.
DTC Code
DTC Detection Condition
Trouble Area
B158F
A video or audio signal is interrupted when the battery voltage drops.
Radio and display receiver assembly

WIRING DIAGRAM

E280911E09

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedure.

HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


1. CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. E268487
    Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (Click here)]

  1. Check that the battery voltage.

    Standard voltage:
    11 to 14 V

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



NG
Go to step 3
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    No DTCs are output.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)

3. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY)

  1. E277492E43
    Disconnect the radio and display receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H49-4 (+B1) - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Radio and Display Receiver Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)


← B158F AV Signal Stoppage (Low Battery Voltage) (Aug 2013 – Jul 2014)B15A3 Stereo Component Amplifier Malfunction (Aug 2013 – Jul 2014) →