2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The radio and display receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from speakers even if there is no malfunction in the stereo component amplifier assembly, DCM (telematics transceiver)* or speakers.
  1. *: w/ Manual (SOS) Switch

WIRING DIAGRAM

E284138E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the H63 stereo component amplifier assembly connector.

  1. Disconnect the H49 radio and display receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H49-1 (FR+) - H63-5 (R+)
    Always
    Below 1 Ω
    H49-2 (FL+) - H63-3 (L+)
    Always
    Below 1 Ω
    H49-5 (FR-) - H63-4 (R-)
    Always
    Below 1 Ω
    H49-6 (FL-) - H63-2 (L-)
    Always
    Below 1 Ω
    H63-6 (SLD) - Body ground
    Always
    10 kΩ or higher
    H49-1 (FR+) - Body ground
    Always
    10 kΩ or higher
    H49-2 (FL+) - Body ground
    Always
    10 kΩ or higher
    H49-5 (FR-) - Body ground
    Always
    10 kΩ or higher
    H49-6 (FL-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Speaker Circuit (from Aug 2014)Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier (from Aug 2014) →