Home › Vehicle Exterior › BODY PANEL › FRONT DOOR OUTER PANEL › from 2017.08
BM27T0E _01 Vehicle Exterior _054380 BODY PANEL _0264637 FRONT DOOR OUTER PANEL F

BODY PANEL  FRONT DOOR OUTER PANEL  ASSEMBLY REPLACEMENT  


K142096

REMOVAL


Symbol Meaning
K108818

Remove Weld Points

REMOVAL POINT
1.

Before removing the outer panel, mark the installation position with tape.

2.

Before removing the outer panel, establish its exact position in relation to the window frame using a reference marker, etc.

3.

After grinding off the hemming location, remove the outer panel.


K125811C02
4.917,1.542 5.229,1.698 0.313,0.156 10 false *a 3.833,2.052 4.073,2.271 0.24,0.219 10 false *b 3.781,5.188 4.094,5.344 0.313,0.156 10 false *c 3.844,7.521 4.156,7.677 0.313,0.156 10 false *d
*a Positioning Tape *b Installation Position
*c Hemming Location *d Disc Sander



INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108833

Spot MIG Weld
K108834

Body Sealer

INSTALLATION POINT
1.

Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and backside of the new parts.

HINT:

Apply sealer evenly about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement and side impact protection beam to make contact.


2.

Bend the flange hem about 30° with a hammer and dolly. Then, fasten tightly with a hemming tool.

HINT:
·

Perform hemming in three steps, being careful not to warp the panel.

·

If a hemming tool cannot be used, hem with a hammer and dolly.



3.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K142099C01
5.25,4.125 5,3.833 false 6,4.167 5.625,4.333 false 6,5.167 5.76,4.927 false 5.833,6.917 5.531,6.615 false 3.604,1.458 3.917,1.615 0.313,0.156 10 false *a 5.99,3.073 6.302,3.229 0.313,0.156 10 false *b 4.865,3.646 5.177,3.802 0.313,0.156 10 false *c 6.021,4.01 6.333,4.167 0.313,0.156 10 false *d 6.042,5.156 6.354,5.313 0.313,0.156 10 false *e 5.875,6.917 6.188,7.073 0.313,0.156 10 false *f 6.667,8.583 6.979,8.74 0.313,0.156 10 false *g 4.542,4.719 5,4.917 0.458,0.198 10 false 30° 4.229,2.948 4.833,3.198 0.604,0.25 10 false 10 (0.39)
*a Positioning Tape *b Do not close the drain hole.
*c Dolly *d Cloth Tape
*e Hammer *f Hemming Tool
*g mm (in.) - -