Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING OR REPLACING PARTS › 2017.08–2020.08
BM27T0E _V1 General _054381 INTRODUCTION _0264665 WHEN REMOVING,INSTALLING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED / RECONNECTED TO BATTERY TERMINAL  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL


Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed
Correction of steering angle neutral point Lane departure alert system
Pre-crash safety system
Lighting system (EXT)(for LED Headlight)
Vehicle stability control system (for Hydraulic Brake Booster)
Multi-terrain monitor system
Parking assist monitor system (for Camera built-in ECU)

NOTICE:
·

After the battery is reconnected, be sure to wait 10 seconds or more before attempting to start the engine. The engine may not start immediately after the battery is reconnected.

·

w/ Navigation System:

After the engine switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the engine switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.