Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
NAME PLATE (for Side)
| *1 | FRONT FENDER PLATE LH | - | - |
| ● | Non-reusable part | - | - |
FRONT FENDER EMBLEM
| *A | for LH Side | *B | for RH Side |
| *a | Reference Values | *b | Fender Relief |
| *c | Fender End Line | *d | 47.7 mm (1.88 in.) |
| *e | 43.7 mm (1.72 in.) | *f | 113.2 mm (4.46 in.) |
| *g | 112.6 mm (4.43 in.) | *h | 153.9 mm (6.06 in.) |
| *i | 44.6 mm (1.76 in.) | *j | 60.1 mm (2.37 in.) |
| *k | 117.5 mm (4.63 in.) | *l | 110.6 mm (4.35 in.) |
| *m | 61.7 mm (2.43 in.) | - | - |
NAME PLATE (w/ Pillar Emblem)
QUARTER PANEL PLATE
| *A | for 5 Door |
| *B | for 3 Door |
| *a | Reference Values |
| *b | Imaginary line extending from bottom edge of quarter window glass. |
NAME PLATE (for Rear with Tire Carrier)
SYMBOL EMBLEM
| *a | Reference Values | *b | Back Door Relief |
| *c | Back Door End Line | - | - |
BACK DOOR NAME PLATE
| *a | Reference Values | *b | Back Door Relief |
| *c | Back Door End Line | - | - |
NAME PLATE (for Rear without Tire Carrier)
SYMBOL EMBLEM
| *1 | Boss |
BACK DOOR NAME PLATE
| *a | Reference Values | *b | Back Door Relief |
| *c | Back Door End Line | - | - |