CONSTRUCTION
Oil Nozzle
A No. 1 oil nozzle sub-assembly for cooling and lubricating the piston has been provided in the cylinder block.
The No. 1 oil nozzle sub-assembly contains a check ball to prevent oil from being fed when the oil pressure is low. This prevents the overall oil pressure in the engine from dropping.
| *1 | Check Ball | *2 | Compression Spring |
2-stage Oil Pressure Switching Oil Pump
The Oil Switching Valve (OSV) is turned on and off according to engine control information, changing the position of the sleeve valve and controlling the discharge pressure of the oil pump in 2 stages. As a result, the piston jet can be turned on and off.
| *1 | Oil Pressure Sensor | *2 | OSV |
| *3 | Oil Pump | *4 | ECM |
| *a | ·
Water Temperature ·
Oil Pressure ·
Engine Evolution ·
Fuel Injection |
*b | Check Valve |
| *c | Sleeve | *d | Spring |
| *e | Guide | *f | Plug |
| *g | Relief Valve | *h | From Oil Pan Sub-assembly |
| *i | To Main Oil Hole | *j | Rotor of Oil Pump |
| *k | The illustration is a representative example. | - | - |
|
Changing oil pump discharge pressure by controlling of sleeve position to 2 stages. |
|
Oil Flow |
High Pressure Control (OSV: OFF)
Oil is not supplied to the rear of the sleeve, so the sleeve is pushed down by the discharge pressure, lowering the relief hole position and increasing the spring force required to open the relief valve. As a result, the opening pressure increases, increasing the discharge pressure.
| *a | Sleeve | *b | From Oil Pan Sub-assembly |
| *c | To Main Oil Hole | *d | Discharge Side |
| *e | Suction Side | *f | Oil Pressure |
| *g | Engine Speed | *h | Opening Pressure of Piston Oil Jet |
|
Oil Flow | - | - |
Low Pressure Control (OSV: ON)
As oil is supplied to the back of the sleeve, the sleeve is pushed up by the discharge pressure, raising the relief hole position and decreasing the spring force required to open the relief valve. As a result, the opening pressure decreases, decreasing discharge pressure.
| *a | Sleeve | *b | From Oil Pan Sub-assembly |
| *c | To Main Oil Hole | *d | Discharge Side |
| *e | Suction Side | *f | Oil Pressure |
| *g | Engine Speed | *h | Opening Pressure of Piston Oil Jet |
|
Oil Flow | - | - |