FUNCTION
Starter Control (Cranking Hold Function)
Models without Stop and Start System
If the certification ECU (smart key ECU assembly) receives a start signal from the engine switch, the certification ECU (smart key ECU assembly) sends an operation signal to the starter relay via the clutch start switch assembly when the clutch pedal is depressed to operate the starter assembly. At this time, the certification ECU (smart key ECU assembly) turns the ACC relay operation signal off to prevent flickering of the meter, clock and audio systems.*1
If the certification ECU (smart key ECU assembly) receives a start signal from the engine switch, the certification ECU (smart key ECU assembly) sends an operation signal to the starter relay via the park/neutral position switch assembly when the shift lever is in P or N to operate the starter assembly. At this time, the certification ECU (smart key ECU assembly) turns the ACC relay operation signal off to prevent flickering of the meter, clock and audio systems.*2
While the engine is cranking, the certification ECU (smart key ECU assembly) continues to send an operation signal to the starter relay until it has been detected that the engine has started successfully. Whether the engine has started successfully is determined by the certification ECU (smart key ECU assembly) and ECM, and once it has been determined that the engine has started successfully, the signal output from the certification ECU (smart key ECU assembly) to the starter relay is stopped.
*1: Models with manual transmission
*2: Models with automatic transmission
Models with Stop and Start System
When first starting the engine, if the certification ECU (smart key ECU assembly) receives a start signal from the engine switch, the certification ECU (smart key ECU assembly) sends an operation signal to the No. 1 ST relay when the shift lever is in P or N and the engine stop and start ECU sends an operation signal to the No. 2 ST relay to operate the starter assembly. At this time, the certification ECU (smart key ECU assembly) turns the ACC relay operation signal (ACCD) off to prevent flickering of the meter, clock and audio systems.
When starting the engine during idling stop control, the engine stop and start ECU sends operation signals to the No. 1 ST relay and No. 2 ST relay according to the vehicle condition to operate the starter assembly.
While the engine is cranking, the certification ECU (smart key ECU assembly) and/or engine stop and start ECU continues to send an operation signal to the No. 1 ST relay until it has been detected that the engine has started successfully. Whether the engine has started successfully is determined by the certification ECU (smart key ECU assembly) and ECM, and once it has been determined that the engine has started successfully, the signal output from the certification ECU (smart key ECU assembly) and/or engine stop and start ECU to the No. 1 ST relay is stopped.
The crank hold time and engine speed when it has been determined that the engine has started successfully are determined according to the engine coolant temperature.
If the engine does not start even though the starter has cranked for 30 seconds, the No. 1 ST relay (starter relay) is turned off to protect the starter motor.