Home › General › SPECIFICATIONS › 1GD-FTV BATTERY / CHARGING
RM27T0E _V1 General _053654 SPECIFICATIONS _0260396 1GD-FTV BATTERY / CHARGING F

SPECIFICATIONS  1GD-FTV BATTERY / CHARGING  SERVICE DATA  


CHARGING SYSTEM
Battery Standard specific gravity 1.25 to 1.29 at 20°C (68°F)
Standard voltage 1.25 to 1.29 V at 20°C (68°F)
Fuse Standard resistance Below 1 Ω
Charging circuit without load Standard current 10 A or higher
Standard voltage 13.5 to 14.35 V
(when engine speed at 2000 rpm)
Charging circuit with load Standard current 30 A or higher

GENERATOR BRUSH HOLDER ASSEMBLY
brush holder Standard exposed length 9.5 to 11.5 mm (0.374 to 0.453 in.)
Minimum exposed length 4.5 mm (0.177 in.)

GENERATOR ROTOR ASSEMBLY
Generator rotor Standard resistance Between the slip rings for 130 A Type 1.55 to 1.95 Ω at 20°C (68°F)
for 100 A Type 1.8 to 2.2 Ω at 20°C (68°F)
Between the slip ring and rotor core 10 kΩ or higher
Standard diameter 14.2 to 14.8 mm (0.559 to 0.583 in.)
Minimum diameter 14.0 mm (0.551 in.)

HARNESS AND CONNECTOR
Tester Connection Condition Specified Condition
C171-7(LIN) - C173-2(LIN) Always Below 1 Ω
C171-7(LIN) - C173-2(LIN) - Body ground Engine switch off
(while LIN communication is stopped)
10 kΩ or higher