Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE
RM27T0E _51 Engine / Hybrid System _053656 2TR-FE ENGINE CONTROL _0260404 CAMSHAFT OIL CONTROL VALVE A

2TR-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSTALLATION  


PROCEDURE

Hide 11101J 1.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side)

a.

Apply a light coat of engine oil to a new O-ring and install the O-ring to the camshaft timing oil control valve assembly.

NOTICE:

Do not damage the O-ring when installing.


HINT:

An O-ring is already installed in a new camshaft timing oil control valve assembly. So, the O-ring only needs to be coated with engine oil when the assembly is replaced with a new one.



b.

Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

Replace with a new part if it is dropped or if it receives a strong impact.

·

Make sure that the O-ring is not cracked or jammed when installing.




c.

Connect the camshaft timing oil control valve connector.


Hide 11101J 2.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side)

a.

Apply a light coat of engine oil to a new O-ring and install the O-ring to the camshaft timing oil control valve assembly.

NOTICE:

Do not damage the O-ring when installing.


HINT:

An O-ring is already installed in a new camshaft timing oil control valve assembly. So, the O-ring only needs to be coated with engine oil when the assembly is replaced with a new one.



b.

Install the camshaft timing oil control valve assembly to the cylinder head sub-assembly with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

Replace with a new part if it is dropped or if it receives a strong impact.

·

Make sure that the O-ring is not cracked or jammed when installing.




c.

Connect the camshaft timing oil control valve connector.


d.

Connect the wiring harness clamp bracket with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Attach the 2 clamps and connect the 2 connectors.