Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › MANIFOLD ABSOLUTE PRESSURE SENSOR
RM27T0E _51 Engine / Hybrid System _053656 2TR-FE ENGINE CONTROL _0260419 MANIFOLD ABSOLUTE PRESSURE SENSOR G

2TR-FE ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421N 1.INSPECT AIR PRESSURE SENSOR

a.

Inspect the power source voltage.

i.

Disconnect the air pressure sensor connector.


ii.

Turn the ignition switch to ON.


iii.
A230590E01
2.621,1.539 2.869,1.689 0.248,0.150 10 VC 0.648,1.539 0.863,1.687 0.215,0.148 10 E2 2.123,1.243 2.505,1.625 2.505,1.625 2.613,1.625 false 1.392,1.243 1.009,1.625 1.009,1.625 0.902,1.625 false 0.118,0.089 0.297,0.256 0.178,0.166 10 *a

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
3 (VC) - 1 (E2) Ignition switch ON 4.75 to 5.25 V


Text in Illustration
*a Front view of wire harness connector
(to Air Pressure Sensor)

If the result is not as specified, inspect the wire harness and ECM.


iv.

Turn the ignition switch off.


v.

Connect the air pressure sensor connector.



b.

Check the pressure.

i.
A273766

Connect a pressure gauge to the air pressure sensor as shown in the illustration.


ii.

Connect the GTS to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the GTS on


v.

Enter the following menus: Powertrain / Engine and ECT / Data List / Air Pump Pressure (absolute).


vi.

Check that the pressure displayed on the GTS fluctuates when applying pressure to the air pressure sensor with the pressure gauge.

OK:

Pressure fluctuates in response to pressure applied with pressure gauge.


HINT:

The GTS displays the air pump pressure (Air Pump Pressure (absolute)) as absolute pressure.


If the result is not as specified, replace the air pressure sensor.