Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › ACCELERATOR PEDAL
RM27T0E _51 Engine / Hybrid System _053657 1GR-FE ENGINE CONTROL _0260425 ACCELERATOR PEDAL G

1GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.


e.

Read the value displayed on the intelligent tester.

Standard Voltage:
Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2
Released 0.5 to 1.1 V 1.2 to 2.0 V
Depressed 2.6 to 4.5 V 3.4 to 5.0 V


If the result is not as specified, check the accelerator pedal, wire harness and ECM.