Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM27T0E _51 Engine / Hybrid System _053657 1GR-FE ENGINE CONTROL _0260428 CRANKSHAFT POSITION SENSOR A

1GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
·

When reusing the sensor, inspect the O-ring.

·

If the O-ring has scratches or cuts, replace the sensor.




b.

Install the sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the sensor connector.


Hide 16630D 2.INSTALL IDLER PULLEY ASSEMBLY (w/o Air Conditioning System)

a.

Install the idler pulley with the 3 bolts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 51405A 3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 88320 4.INSTALL COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)

Hide 27020 5.INSTALL GENERATOR ASSEMBLY