Home › Engine / Hybrid System › 1KD-FTV (ENGINE CONTROL) › DIESEL THROTTLE BODY › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053659 1KD-FTV ENGINE CONTROL _0260446 DIESEL THROTTLE BODY A

1KD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 26100G 1.INSTALL DIESEL THROTTLE BODY ASSEMBLY

a.

Install a new gasket and the diesel throttle body with the 2 bolts and 2 nuts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Connect the throttle position sensor connector.


Hide 17113E 2.INSTALL NO. 1 INTAKE PIPE

a.

Connect the No. 1 intake pipe with the air hose and install the 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Tighten the 2 clamps of the No. 1 air hose.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


c.

Tighten the clamp of the intercooler air hose.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


d.

Connect the vacuum hose to the manifold absolute pressure sensor connector.


e.

Connect the 3 connectors to the intake air temperature sensor, throttle control motor and manifold absolute pressure sensor.


f.

Attach the 2 clamps.


Hide 25709E 3.CONNECT NO. 4 VACUUM TRANSMITTING PIPE SUB-ASSEMBLY

a.

Connect the No. 4 vacuum transmitting pipe with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 87245A 4.CONNECT INLET HEATER WATER HOSE

a.

Connect the inlet heater water hose with the bolt.

Torque:
26 N*m (260 kgf*cm, 19 ft.*lbf)