Home › Engine / Hybrid System › 1KD-FTV (ENGINE CONTROL) › DIESEL THROTTLE BODY › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053659 1KD-FTV ENGINE CONTROL _0260446 DIESEL THROTTLE BODY A

1KD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 87245A 1.DISCONNECT INLET HEATER WATER HOSE

a.
A224418

Remove the bolt and disconnect the inlet heater water hose.


Hide 25709E 2.DISCONNECT NO. 4 VACUUM TRANSMITTING PIPE SUB-ASSEMBLY

a.
A222558

Remove the bolt and disconnect the No. 4 vacuum transmitting pipe.


Hide 17113E 3.REMOVE NO. 1 INTAKE PIPE

a.
A222559

Disconnect the 3 connectors from the intake air temperature sensor, throttle control motor and manifold absolute pressure sensor.


b.

Detach the 2 clamps.


c.

Disconnect the vacuum hose from the manifold absolute pressure sensor.


d.
A222560

Loosen the 2 hose clamps of the No. 1 air hose.


e.
A222561

Loosen the hose clamp of the intercooler air hose.


f.
A222562

Remove the 2 bolts and No. 1 intake pipe.


Hide 26100G 4.REMOVE DIESEL THROTTLE BODY ASSEMBLY

a.
A222563

Disconnect the throttle position sensor connector.


b.
A222564

Remove the 2 bolts, 2 nuts, diesel throttle body and gasket.