Home › Engine / Hybrid System › 1KD-FTV (ENGINE CONTROL) › ECD SYSTEM › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053659 1KD-FTV ENGINE CONTROL _0260458 ECD SYSTEM D

1KD-FTV ENGINE CONTROL  ECD SYSTEM  CHECK MODE PROCEDURE  


HINT:

Intelligent tester only:

Compared to normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.


NOTICE:

All the stored DTCs and freeze frame data are cleared if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.


CHECK MODE PROCEDURE (Using Intelligent Tester)


a.

Check that the following conditions are met:

i.

Battery positive voltage is 11 V or higher.


ii.

Throttle valve is fully closed.


iii.

Transmission is in neutral.


iv.

A/C is switched off.



b.

Turn the ignition switch off.


c.

Connect the intelligent tester to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the tester on.


f.

Enter the following menus: Utility / Check Mode.


g.

Switch the ECM from normal mode to check mode.


h.
A208457E01
0.094,0.844 0.385,1.115 0.292,0.271 10 false ON 0.073,1.417 0.406,1.677 0.333,0.26 10 false OFF 2.042,0.438 2.958,0.719 0.917,0.281 10 false 0.13 seconds 1.948,1.802 2.885,2.063 0.938,0.26 10 false 0.13 seconds

Make sure the MIL flashes as shown in the illustration.


i.

Start the engine.


j.

Make sure the MIL turns off.


k.

Simulate the conditions of the malfunction described by the customer.


l.

Check for DTCs and freeze frame data using the tester.


m.

After checking for DTCs, inspect the applicable circuits.