Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › NITROGEN OXIDES SENSOR › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260460 NITROGEN OXIDES SENSOR A

1GD-FTV ENGINE CONTROL  NITROGEN OXIDES SENSOR  INSTALLATION  


PROCEDURE

Hide 89463A 1.INSTALL NITROGEN OXIDES SENSOR

a.

Install the No. 1 sensor bracket with the 2 nuts to the nitrogen oxides sensor, and attach the 2 clamps.


b.
A353020E02
1.573,0.875 1.927,1.271 1.927,1.271 2.021,1.271 true 2.073,1.188 2.479,1.375 0.406,0.188 10 true SST 0.469,1 0.729,1.198 0.26,0.198 10 true *a

Using SST, install the nitrogen oxides sensor.

SST
09922-10010  

Torque:
Specified tightening torque : 70 N*m (714 kgf*cm, 52 ft.*lbf)

Text in Illustration
*a Torque Wrench Fulcrum Length

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When using SST (fulcrum length of 132 mm (5.20 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 46 N*m (470 kgf*cm, 34 ft.*lbf)




c.

Install the controller portion (No. 1 sensor bracket) with the 2 bolts, and then attach the connector and 3 clamps.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

Complete the installation so that there is no tension or slack in the harness of the nitrogen oxides sensor, and there is no interference.



Hide 89439K 2.INSTALL NO. 3 SENSOR BRACKET

a.

Install the No. 3 sensor bracket with the 2 bolts.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)