Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ Urea SCR System) › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260461 ECD SYSTEM(w/ Urea SCR System) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  P2226  Barometric Pressure Circuit  P2228  Barometric Pressure Circuit Low Input  P2229  Barometric Pressure Circuit High Input  


DESCRIPTION

To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used. Using the atmospheric pressure, the ECM corrects the injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.

P2226
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Engine switch on (IG) for 1 second or more Atmospheric pressure sensor voltage is 1.4 V or less, or 4.0 V or higher for 0.5 seconds (1 trip detection logic). ECM

P2228
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Engine switch on (IG) for 1 second or more Atmospheric pressure sensor voltage is 1.4 V or less for 0.5 seconds (1 trip detection logic). ECM

P2229
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Engine switch on (IG) for 1 second or more Atmospheric pressure sensor voltage is 4.0 V or higher for 0.5 seconds (1 trip detection logic). ECM

Related Data List
DTC No. Data List
P2226
P2228
P2229
·

Atmosphere Pressure

·

MAP



HINT:
·

When the engine switch is on (IG), the intake manifold pressure, "MAP", is approximately equal to atmospheric pressure.

·

Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in elevation, pressure drops by 1 kPa. This varies by weather (high atmospheric pressure, low atmospheric pressure).

·

If DTC P2226, P2228 and/or P2229 is stored, the following symptoms may appear:

-

Misfire

-

Combustion noise

-

Black smoke

-

White smoke




CAUTION / NOTICE / HINT

NOTICE:

After replacing the ECM, the new ECM needs registration (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>REGISTRATION) and initialization (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>INITIALIZATION).


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.REPLACE ECM

NEXT

2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the GTS on.



d.

Turn the engine switch off and wait for 30 seconds.


e.

Turn the engine switch on (IG) and wait for 1 second or more.


f.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


g.

Confirm that the DTC is not output again.



NEXT

END