After the engine switch is turned off, the ECM performs turbocharger nozzle vane plate soot removal control (current opening angle→fully opened→fully closed). Monitor the motor drive current value while these opening and closing operations are performed. If the value exceeds the threshold, it can be determined that movement is abnormal. If the system judges that abnormal movements have occurred twice, this DTC is stored, and a message is displayed on the multi-information display the next time the engine switch is turned to on (IG).
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
|---|---|---|
| Turn the engine switch off, and then perform turbocharger nozzle vane plate soot removal control. | During soot removal control of the nozzle vane plate after the engine switch is turned off, DC motor operation current exceeds the threshold.
(2 trip detection logic) |
Abnormality in sliding movement of turbocharger nozzle vane plate |
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P2263 is output | A |
| DTC P2263 and other DTCs are output | B |
A
B
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the GTS on.
Start the engine and warm it up until the engine coolant temperature is 77°C (170°F) or higher with all the accessories switched off .
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VN Turbo Cleaning.
Perform the Active Test.
VN turbo cleaning finishes 20 minutes after the speed increases.
If actions such as depressing the accelerator pedal or operating the shift lever are performed, cleaning control is stopped. If this occurs, it is necessary to perform the procedure again.
NEXT
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG).
Check the multi-information display.
| Result | Proceed to |
|---|---|
| Message displayed in multi-information display | A |
| Message not displayed in multi-information display | B |
A
B
Replace the turbocharger sub-assembly (See page Engine / Hybrid System>1GD-FTV (INTAKE / EXHAUST)>EXHAUST MANIFOLD W/ TURBOCHARGER>REMOVAL).
NEXT
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG).
Check that a message is not displayed in the multi-information display.
Connect the GTS to the DLC3.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Clear.
Clear the DTC.
NEXT