12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Detach the 2 front clips of the No. 1 engine cover sub-assembly.
While pulling the No. 1 engine cover sub-assembly towards the front, detach the 2 rear pins, and then remove the No. 1 engine cover sub-assembly.
17342F
2.REMOVE NO. 2 INTERCOOLER AIR HOSE
Slide the 2 clips and disconnect the oil return hose.
Loosen the 2 hose clamps and remove the No. 2 intercooler air hose.
17360A
3.REMOVE AIR TUBE ASSEMBLY
Detach the clamp and disconnect the No. 1 fuel hose from the air tube support bracket.
Remove the 3 bolts and air tube support bracket.
Disconnect the connector from the intake air temperature sensor.
Loosen the hose clamp and remove the air tube assembly from the diesel throttle body assembly.
26100G
4.REMOVE DIESEL THROTTLE BODY ASSEMBLY
Remove the 2 bolts and 2 nuts, disconnect the diesel throttle body assembly, and then remove the gasket.
Disconnect the connector.
except Cold Area Specification Vehicles:
Detach the clamp, disconnect the emission control valve wire from the wire harness clamp bracket, and then remove the diesel throttle body assembly.
for Cold Area Specification Vehicles:
Detach the clamp, and then disconnect the emission control valve wire from the wire harness clamp bracket.
for Cold Area Specification Vehicles:
Slide the 2 clips and disconnect the No. 11 water by-pass hose and No. 14 water by-pass hose and remove the diesel throttle body assembly.
Disconnect the connector to remove the emission control valve wire from the diesel throttle body assembly.