Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › MASS AIR FLOW METER
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260464 MASS AIR FLOW METER G

1GD-FTV ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY

a.
A346002E02
0.472,1.389 0.697,1.605 0.225,0.216 10 *a 0.684,1.504 0.798,1.504 0.798,1.504 1.715,0.919 false

Perform a visual check for any foreign matter on the temperature sensor (thermistor) of the intake mass air flow meter sub-assembly shown in the illustration.

OK:

There is no foreign matter.


Text in Illustration
*a Thermistor

If the result is not as specified, replace the intake mass air flow meter sub-assembly.


b.
A334358E03
0.07,0.059 0.323,0.275 0.253,0.216 10 *a 0.305,0.466 0.693,0.677 0.387,0.211 10 THA 2.551,0.466 2.920,0.673 0.369,0.207 10 E2G 0.706,0.552 0.809,0.552 0.809,0.552 1.236,1.18 false 2.499,0.552 2.402,0.552 2.402,0.552 1.91,1.175 false

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (THA) - 2 (E2G) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ


Text in Illustration
*a Component without harness connected
(Intake Mass Air Flow Meter Sub-assembly)

If the result is not as specified, replace the intake mass air flow meter sub-assembly.