89467B
1.INSTALL AIR FUEL RATIO SENSOR
Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.
w/o Urea SCR System: (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION)
w/ Urea SCR System: (See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>INITIALIZATION)
Using SST, install the air fuel ratio sensor to the front exhaust pipe.
| *a | Torque Wrench Fulcrum Length |
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 38 N*m (384 kgf*cm, 28 ft.*lbf)
Connect the connector and 2 clamps.
53736B
2.INSTALL NO. 1 FRONT FENDER APRON TO FRAME SEAL RH
Install the No. 1 front fender apron to frame seal RH with the 5 clips.