13511
1.INSPECT CAMSHAFT
Inspect the circle runout.
Place the camshaft on V-blocks.
Using a dial indicator, measure the circle runout at the center journal.
0.10 mm (0.00394 in.)
If the circle runout is more than the maximum, replace the camshaft.
Using a micrometer, measure the cam lobe height.
| Cam Lobe | Specified Condition |
|---|---|
| Intake | 54.890 to 54.910 mm (2.1610 to 2.1618 in.) |
| Exhaust | 54.990 to 55.010 mm (2.1650 to 2.1657 in.) |
| cam Lobe | Specified Condition |
|---|---|
| Intake | 54.39 mm (2.141 in.) |
| Exhaust | 54.49 mm (2.145 in.) |
If the cam lobe height is less than the minimum, replace the camshaft.
17111
2.INSPECT INTAKE MANIFOLD
Using a precision straightedge and feeler gauge, measure the surface that contact the cylinder head for warpage.
0.40 mm (0.0157 in.)
If the warpage is more than the maximum, replace the intake manifold.
17141
3.INSPECT EXHAUST MANIFOLD
Using a precision straightedge and feeler gauge, measure the surface that contact the cylinder head for warpage.
0.40 mm (0.0157 in.)
If the warpage is more than the maximum, replace the exhaust manifold.
11101A
4.INSPECT CYLINDER HEAD SET BOLT
Using a vernier caliper, measure the minimum outer diameter of the elongated thread at the measuring point.
11.80 to 12.00 mm (0.465 to 0.472 in.)
11.60 mm (0.457 in.)
| *a | Measuring Point |
| *b | Elongated Thread |
If the diameter is less than the minimum, replace the cylinder head set bolt.