Bore all 4 cylinders to fit the O/S piston outside diameter.
Replace all the piston rings with ones to match the O/S pistons.
1.BORE CYLINDER
Prepare 4 new O/S pistons.
Using a micrometer, measure the piston diameter at right angles to the piston center line where the distance from the piston end is as specified.
95.471 to 95.481 mm (3.7587 to 3.7591 in.)
13.8 mm (0.543 in.)
| *a | Distance |
Calculate the amount each cylinder is to be rebored as follows.
Size to be rebored = P + C - H
P = Piston diameter
C = Piston oil clearance: 0.009 to 0.048 mm (0.000354 to 0.00189 in.)
H = Allowance for honing: 0.02 mm (0.000787 in.) or less
Bore and hone the cylinders to the calculated dimensions.
Excess honing will destroy the finished roundness.
Using a cylinder gauge, measure the cylinder bore diameter and calculate the honing allowance.
Honing allowance = cylinder bore diameter - (piston diameter + oil clearance)
Finish the cylinder bore using the calculated value.
Using a cylinder gauge, measure the cylinder bore diameter.
0.009 to 0.048 mm (0.000354 to 0.00189 in.)
| *a | Thrust Direction |
| *b | Axial Direction |
|
Front |