Home › Engine / Hybrid System › 1KD-FTV (ENGINE MECHANICAL) › DRIVE BELT › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053664 1KD-FTV ENGINE MECHANICAL _0260513 DRIVE BELT G

1KD-FTV ENGINE MECHANICAL  DRIVE BELT  INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT FAN AND GENERATOR V BELT

a.
B000543

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the fan and generator V belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
B000540E20
0.563,0.313 0.729,0.51 0.167,0.198 10 false *a 2.24,0.313 2.406,0.479 0.167,0.167 10 false *b

Check that the belt fits properly in the ribbed grooves.

Text in Illustration
*a CORRECT
*b INCORRECT

HINT:

Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



c.
A271098E01
0.895,0.197 1.032,0.357 0.138,0.160 10 A 0.241,0.198 0.378,0.358 0.138,0.160 10 B 0.579,0.345 0.445,0.284 0.445,0.284 0.388,0.284 false 0.748,0.452 0.831,0.283 0.831,0.283 0.885,0.283 false

Check that the tensioner indicator mark is within range B shown in the illustration.

If the mark is not within range B, replace the fan and generator V belt.

HINT:

If a new belt has been installed, check that the tensioner indicator mark is within range A.