1.INSTALL STUD BOLT
If a stud bolt is deformed or the threads are damaged, replace it.
Using an E6 "TORX" socket wrench, install the stud bolts labeled A to the cylinder head sub-assembly.
Install the stud bolts labeled B to the cylinder head sub-assembly.
Using an E10 "TORX" socket wrench, install the stud bolts labeled C and D to the cylinder head sub-assembly.
| *a | Cylinder Head Cover Sub-assembly Side | *b | Exhaust Manifold Side |
| *c | Intake Manifold Side | *d | 12 mm (0.472 in.) |
| *e | 37 mm (1.46 in.) | *f | 34 mm (1.34 in.) |
| *g | 23 mm (0.906 in.) | *h | 15 mm (0.591 in.) |
| *i | 25 mm (0.984 in.) | *j | 65 mm (2.56 in.) |
| *k | 40 mm (1.57 in.) | - | - |
11117E
2.INSTALL NO. 1 STRAIGHT SCREW PLUG WITH HEAD
Using a 6 mm hexagon wrench, install 4 new No. 1 straight screw plug with heads to the cylinder head sub-assembly.
13711E
3.INSTALL VALVE STEM OIL SEAL
| *a | Type A |
| *b | Type B |
When installing type B valve stem oil seals, do not install the valve spring seats.
w/ Valve Spring Seat:
Install the valve spring seats to the cylinder head sub-assembly.
Apply a light coat of engine oil to new valve stem oil seals.
| *1 | Valve Stem Oil Seal |
| *a | CORRECT |
| *b | INCORRECT |
Using SST, push in the intake valve stem oil seals and exhaust valve stem oil seals to the valve guide bush.
Failure to use SST will cause the valve stem oil seal to be damaged or improperly seated.
w/o Valve Spring Seat:
Apply a light coat of engine oil to new valve stem oil seals.
| *1 | Valve Stem Oil Seal |
| *a | CORRECT |
| *b | INCORRECT |
Using SST, push in the intake valve stem oil seals and exhaust valve stem oil seals to the valve guide bush.
Failure to use SST will cause the valve stem oil seal to be damaged or improperly seated.
13711
4.INSTALL INTAKE VALVE
Apply plenty of engine oil to the tip area of the intake valve shown in the illustration.
| *a | 30 mm (1.18 in.) or more |
Install the intake valve, valve compression spring and valve spring retainer to the cylinder head sub-assembly.
Install the same parts in the same combination to their original locations.
Using SST and wooden blocks, compress the valve compression spring and install the valve spring retainer locks to the valve spring retainer.
Using a plastic-faced hammer, lightly tap the intake valve stem tip to ensure a proper fit.
Be careful not to damage the valve spring retainer.
13715
5.INSTALL EXHAUST VALVE
Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.
| *a | 30 mm (1.18 in.) or more |
Install the exhaust valve, valve compression spring and valve spring retainer to the cylinder head sub-assembly.
Install the same parts in the same combination to their original locations.
Using SST and wooden blocks, compress the valve compression spring and install the valve spring retainer locks to the valve spring retainer.
Using a plastic-faced hammer, lightly tap the exhaust valve stem tip to ensure a proper fit.
Be careful not to damage the valve spring retainer.
13716
6.INSTALL VALVE STEM CAP
Apply a light coat of engine oil to the valve stem caps.
Install the 16 valve stem caps to the cylinder head sub-assembly.
Install the valve stem cap at the same place it was removed from.
Do not drop the valve stem caps into the cylinder head sub-assembly.