Home › Engine / Hybrid System › 1GD-FTV (ENGINE MECHANICAL) › DRIVE BELT
RM27T0E _51 Engine / Hybrid System _053665 1GD-FTV ENGINE MECHANICAL _0260524 DRIVE BELT A

1GD-FTV ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.

Set the fan and generator V belt onto each part.

HINT:

When installing the fan and generator V belt, attach the fan and generator V belt to the No. 1 idler pulley sub-assembly last.



b.

While turning the V-ribbed belt tensioner assembly clockwise, remove the pin.


c.

Check that the fan and generator V belt fits properly in the ribbed grooves.

NOTICE:

Make sure that the fan and generator V belt is set properly on each pulley.



Hide 88359 2.INSTALL VISCOUS HEATER V BELT (w/ Viscous Heater)

a.

Install the viscous heater V belt.


b.
A346688

Turn the bolt and adjust the tension of the viscous heater V belt.


c.
A358234

Tighten the 2 bolts.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


d.

Check the tension of the viscous heater V belt (See page Engine / Hybrid System>1GD-FTV (ENGINE MECHANICAL)>DRIVE BELT>ON-VEHICLE INSPECTION).


Hide 51405A 3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Viscous Heater)