1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
77606C
4.REMOVE NO. 2 FUEL TANK PROTECTOR
Remove the 5 bolts and No. 2 fuel tank protector.
5.DISCONNECT FUEL HOSE
Disconnect the fuel evaporation hose, fuel breather hose and fuel hose.
77213B
6.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Disconnect the fuel tank to filler pipe hose from the filler pipe.
77269A
7.DISCONNECT FUEL TANK BREATHER HOSE
Disconnect the fuel tank breather hose from the filler pipe.
77100Z
8.REMOVE FUEL SUB TANK SUB-ASSEMBLY
Disconnect the fuel sender gauge assembly connector.
Set an engine lifter underneath the fuel sub tank sub-assembly.
Remove the 4 bolts and disconnect the 2 fuel tank bands.
Remove the fuel sub tank sub-assembly.
77010
9.REMOVE FUEL TANK VENT TUBE ASSEMBLY
Detach the wire harness clamp.
Remove the 8 screws and fuel tank vent tube assembly.
Be careful not to bend the arm of the fuel sender gauge assembly.
Remove the gasket from the fuel tank vent tube assembly.
77213B
10.REMOVE FUEL TANK TO FILLER PIPE HOSE
Remove the fuel tank to filler pipe hose from the fuel sub tank sub-assembly.
77269A
11.REMOVE FUEL TANK BREATHER HOSE
Remove the fuel tank breather hose from the fuel sub tank sub-assembly.