Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL SUB TANK › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053667 1GR-FE FUEL _0260549 FUEL SUB TANK A

1GR-FE FUEL  FUEL SUB TANK  INSTALLATION  


PROCEDURE

Hide 77269A 1.INSTALL FUEL TANK BREATHER HOSE

a.

Install the fuel tank breather hose to the fuel sub tank.


Hide 77213B 2.INSTALL FUEL TANK TO FILLER PIPE HOSE

a.

Install the fuel tank to filler pipe hose to the fuel sub tank.


Hide 77010 3.INSTALL FUEL TANK VENT TUBE ASSEMBLY

a.

Install a new gasket and the fuel tank vent tube with the 8 screws.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


b.

Attach the wire harness clamp.


Hide 77100Z 4.INSTALL FUEL SUB TANK SUB-ASSEMBLY

a.

Set the fuel sub tank on a transmission jack and lift up the transmission jack.


b.

Connect the 2 fuel tank bands with the 4 bolts.

Torque:
40 N*m (408 kgf*cm, 30 ft.*lbf)


c.

Connect the fuel sender gauge connector.


Hide 77269A 5.CONNECT FUEL TANK BREATHER HOSE

a.

Connect the fuel tank breather hose to the filler pipe.


Hide 77213B 6.CONNECT FUEL TANK TO FILLER PIPE HOSE

a.

Connect the fuel tank to filler pipe hose to the filler pipe.


Hide 7.CONNECT FUEL HOSE

a.

Connect the fuel evaporation hose, fuel breather hose and fuel hose.


Hide 77606C 8.INSTALL NO. 2 FUEL TANK PROTECTOR

a.

Install the No. 2 fuel tank protector with the 5 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).