Home › Engine / Hybrid System › 5L-E (FUEL) › FUEL INJECTION NOZZLE
RM27T0E _51 Engine / Hybrid System _053668 5L-E FUEL _0260559 FUEL INJECTION NOZZLE A

5L-E FUEL  FUEL INJECTION NOZZLE  REASSEMBLY  


PROCEDURE

Hide 23624 1.INSTALL NOZZLE RETAINING NUT

a.
FU01353E06
1.125,1.271 1.5,1.115 1.5,1.115 1.115,0.948 true 1.531,1.042 2.198,1.354 0.667,0.313 10 true SST

Install the pressure pin, distance piece and nozzle assembly to the nozzle retaining nut.


b.

Install the nozzle holder pressure spring and adjusting shim, and then temporarily install the nozzle holder to the nozzle retaining nut.


c.

Using SST, tighten the nozzle retaining nut.

SST
09268-64010  (09268-64020, 09268-64030)

Torque:
47 N*m (475 kgf*cm, 34 ft.*lbf)

NOTICE:

Overtightening could cause nozzle deformation and needle adhesion or other defects.



d.

Inspect the holder and nozzle set.


Hide 23628 2.INSTALL RING PACKING SETTING NUT

a.

Install a new washer and the ring packing setting nut.