Home › Engine / Hybrid System › 1GD-FTV (FUEL) › FUEL FILTER
RM27T0E _51 Engine / Hybrid System _053670 1GD-FTV FUEL _0260585 FUEL FILTER A

1GD-FTV FUEL  FUEL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

When replacing the fuel filter element assembly, use TOYOTA genuine parts or equivalent parts.

·

When replacing the fuel filter element assembly, clean the fuel filter cap and remove dirt completely.



PROCEDURE

Hide 23300 1.REMOVE FUEL FILTER ASSEMBLY

a.
A339758

Disconnect the 2 connectors.


b.

Slide the 4 clamps and disconnect the fuel hose, No. 1 fuel hose sub-assembly, No. 3 fuel hose and No. 2 fuel hose from the fuel filter assembly.


c.

Remove the 2 nuts and fuel filter assembly.


Hide 2.DRAIN FUEL

a.
A223226

Loosen the fuel filter drain plug and drain the fuel from the fuel filter assembly.


Hide 23931A 3.REMOVE FUEL FILTER COVER

a.
A223228

Detach the level warning switch connector clamp from the fuel filter cap.


b.

Remove the bolt, fuel filter cover and fuel filter gasket from the fuel filter element assembly.


Hide 23390 5.REMOVE FUEL FILTER ELEMENT ASSEMBLY

a.
A223230E01
3.005,0.658 3.333,0.804 0.329,0.146 10 SST 2.378,0.74 2.952,0.74 false

Using SST, remove the fuel filter element assembly.

SST
09228-64010  


Hide 23390 6.INSTALL FUEL FILTER ELEMENT ASSEMBLY

a.

Check and clean the installation surface of the fuel filter element assembly.


b.

Apply diesel fuel to the gasket of a new fuel filter element assembly.


c.
A339847

Lightly screw the fuel filter element assembly into place and tighten it until the gasket comes into contact with the seat.


d.

Tighten the fuel filter element assembly an additional 3/4 turn by hand.


Hide 23931A 8.INSTALL FUEL FILTER COVER

a.

Install the fuel filter gasket and fuel filter cover to the fuel filter element assembly.


b.

Tighten the bolt.

Torque:
3.4 N*m (35 kgf*cm, 30 in.*lbf)


c.

Attach the level warning switch connector clamp to the fuel filter cap.


Hide 23300 9.INSTALL FUEL FILTER ASSEMBLY

a.

Install the fuel filter assembly with the 2 nuts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


b.

Connect the fuel hose, No. 1 fuel hose sub-assembly, No. 3 fuel hose and No. 2 fuel hose to the fuel filter assembly, and slide the 4 clamps to secure the hoses.


c.

Connect the 2 connectors.