Home › Engine / Hybrid System › 1GD-FTV (FUEL) › FUEL INJECTOR › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053670 1GD-FTV FUEL _0260590 FUEL INJECTOR G

1GD-FTV FUEL  FUEL INJECTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 23670 1.CHECK INJECTOR ASSEMBLY

a.

Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.


b.

Allow the engine to idle for 1 minute or more.


c.

Connect the GTS to the DLC3.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine and ECT / Data List / Injection Volume and Injection Feedback Val. #1 to #4.


f.

Read the values when the engine is idling.


g.

Check that the "Injection Feedback Val. #1 to #4" values are within the specification.

Standard:
Tester Display Engine Condition Specified Condition
Injection Volume Idling 3 to 10 mm3/st
Injection Feedback Val. #1
Injection Feedback Val. #2
Injection Feedback Val. #3
Injection Feedback Val. #4
Idling -3.0 to 3.0 mm3/st


If the result is not as specified, replace the fuel injector assembly.


Hide 2. INJECTOR COMPENSATION CODE

HINT:

If the injector compensation code is not correctly registered, it may cause malfunctions.



b.

Check that the compensation code of the installed injector assembly is the same as the code registered in the ECM. If the code is not the same, register the injector compensation code on the injector assembly.

(See page Engine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ Urea SCR System)>REGISTRATION)