Home › Engine / Hybrid System › 1GR-FE (EMISSION CONTROL) › AIR SWITCHING VALVE (for Bank 1)
RM27T0E _51 Engine / Hybrid System _053672 1GR-FE EMISSION CONTROL _0260603 AIR SWITCHING VALVE(for Bank 1) G

1GR-FE EMISSION CONTROL  AIR SWITCHING VALVE(for Bank 1)  INSPECTION  


PROCEDURE

Hide 25701 1.INSPECT EMISSION CONTROL VALVE SET

a.
A224402E01
0.059,0 0.252,0.184 0.193,0.184 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 5 20°C (68°F) 4.5 to 5.5 Ω
1 - Body ground Always 1 MΩ or higher
5 - Body ground


Text in Illustration
*a Component without harness connected
(Emission Control Valve Set)

HINT:
·

When measuring the resistance, do not touch terminals 2, 3 or 4.

·

When measuring the resistance make sure that the surface temperature of the emission control valve set is 20°C.



If the result is not as specified, replace the emission control valve set.


b.
A224403C02
3.188,1.729 3.115,1.729 3.115,1.729 2.927,1.958 false 2.771,1.333 2.667,1.333 2.667,1.333 2.438,1.677 false 1.063,2.438 1.063,2.938 true 3.229,1.635 3.406,1.792 0.177,0.156 10 false *1 1,2.979 1.177,3.135 0.177,0.156 10 false *3 2.802,1.24 2.979,1.396 0.177,0.156 10 false *2

Check the operation of the emission control valve set.

i.

Check that air does not flow from port A to port B.

Text in Illustration
*1 Air
*2 Port A
*3 Port B

NOTICE:

Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.


If the result is not as specified, replace the emission control valve set.


ii.
A224404C02
3.094,3.26 2.969,3.26 2.969,3.26 2.844,3.542 false 2.615,2.906 2.51,2.906 2.51,2.906 2.354,3.24 false 1.406,4.479 1.313,4.479 1.313,4.479 1.031,3.99 true 2.635,2.823 2.802,2.99 0.167,0.167 10 false *2 1.458,4.365 1.625,4.531 0.167,0.167 10 false *3 3.135,3.146 3.302,3.313 0.167,0.167 10 false *1

Apply battery voltage across terminals 1 and 5.

NOTICE:

When applying voltage, do not touch terminals 2, 3 or 4.



iii.

Check that air flows from port A to port B.

Text in Illustration
*1 Air
*2 Port A
*3 Port B

If the result is not as specified, replace the emission control valve set.