Home › Engine / Hybrid System › 1GR-FE (EMISSION CONTROL) › AIR SWITCHING VALVE(for Bank 2)
RM27T0E _51 Engine / Hybrid System _053672 1GR-FE EMISSION CONTROL _0260604 AIR SWITCHING VALVE(for Bank 2) G

1GR-FE EMISSION CONTROL  AIR SWITCHING VALVE(for Bank 2)  INSPECTION  


PROCEDURE

Hide 25702 1.INSPECT NO. 2 EMISSION CONTROL VALVE SET

a.
A224405C02
0.052,0.01 0.229,0.177 0.177,0.167 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 5 20°C (68°F) 4.5 to 5.5 Ω
1 - Body ground Always 1 MΩ or higher
5 - Body ground


Text in Illustration
*a Component without harness connected
(No. 2 Emission Control Valve Set)

HINT:
·

When measuring the resistance, do not touch terminals 2, 3 or 4.

·

When measuring the resistance make sure that the surface temperature of the No. 2 emission control valve set is 20°C.



If the result is not as specified, replace the No. 2 emission control valve set.


b.

Check the operation of the No. 2 emission control valve set.

i.
A224406C02
0.948,1.24 1.042,1.24 1.042,1.24 1.115,1.573 false 0.417,2.104 0.51,2.104 0.51,2.104 0.583,1.802 false 1.948,2.198 1.948,2.781 true 0.219,2.021 0.396,2.198 0.177,0.177 10 false *1 0.75,1.177 0.927,1.354 0.177,0.177 10 false *2 1.885,2.844 2.063,3.021 0.177,0.177 10 false *3

Check that air does not flow from port A to port B.

Text in Illustration
*1 Air
*2 Port A
*3 Port B

NOTICE:

Make sure the applied pressure is 30 kPa (0.3 kgf/cm2, 4.4 psi) or less.


If the result is not as specified, replace the No. 2 emission control valve set.


ii.
A224407C02
0.24,3.146 0.313,3.146 0.313,3.146 0.354,3.438 false 0.76,2.865 0.833,2.865 0.833,2.865 0.906,3.229 false 1.552,4.323 1.552,4.229 1.552,4.229 1.635,3.844 true 1.479,4.333 1.656,4.5 0.177,0.167 10 false *3 0.063,3.094 0.24,3.26 0.177,0.167 10 false *1 0.563,2.771 0.74,2.938 0.177,0.167 10 false *2

Apply battery voltage across terminals 1 and 5.

NOTICE:

When applying voltage, do not touch terminals 2, 3 or 4.



iii.

Check that air flows from port A to port B.

Text in Illustration
*1 Air
*2 Port A
*3 Port B

If the result is not as specified, replace the No. 2 emission control valve set.