Home › Engine / Hybrid System › 1KD-FTV (EMISSION CONTROL) › EMISSION CONTROL SYSTEM › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053673 1KD-FTV EMISSION CONTROL _0260614 EMISSION CONTROL SYSTEM G

1KD-FTV EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:

In a malfunction where the EGR system is always on, black or white smoke may be emitted from the exhaust pipe.

If this occurs, inspect the EGR system (See page Engine / Hybrid System>1KD-FTV (EMISSION CONTROL)>EGR VALVE>ON-VEHICLE INSPECTION).


PROCEDURE

Hide 1.CHECK FOR LEAKS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil dipstick, filler cap, PCV hose or other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.



If the result is not as specified, replace parts as necessary.


Hide 29300 2.CHECK VACUUM PUMP ASSEMBLY

C111341E03
2.986,0.29 3.146,0.457 0.159,0.167 10 *1 2.706,1.149 2.868,1.307 0.161,0.159 10 *2 2.568,0.381 2.983,0.381 false 3.1,1.719 2.954,1.239 2.954,1.239 2.886,1.239 false

a.

Disconnect the vacuum hose from the vacuum pump.


b.

Connect the hose of a vacuum gauge to the pump.

Text in Illustration
*1 Vacuum Gauge
*2 Plug


c.

Insert a plug into the other hose of the gauge.


d.

Start the engine and warm it up for more than 2 minutes.


e.

With the engine idling, measure the negative pressure of the pump.

Standard negative pressure:

Higher than 87 kPa (650 mmHg, 25.6 in.Hg)



f.

Remove the gauge from the pump.


g.

Connect the hose to the pump with the clip.