Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › EXHAUST GAS TEMPERATURE SENSOR (for Rear)
RM27T0E _51 Engine / Hybrid System _053675 1GD-FTV EMISSION CONTROL _0260628 EXHAUST GAS TEMPERATURE SENSOR(for Rear) A

1GD-FTV EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR(for Rear)  INSTALLATION  


PROCEDURE

Hide 89425C 1.REMOVE NO. 4 EXHAUST GAS TEMPERATURE SENSOR

a.
A329093E06
1.759,0.583 1.944,0.738 0.185,0.155 10 *a

Using a 14 mm union nut wrench, install the No. 4 exhaust gas temperature sensor to the center exhaust pipe assembly.

Torque:

Specified tightening torque

30 N*m {306 kgf*cm, 22 ft.*lbf}


NOTICE:

If the No. 4 exhaust gas temperature sensor is dropped, replace the new one.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 26 N*m (268 kgf*cm, 19 ft.*lbf)



Text in Illustration
*a Torque Wrench Fulcrum Length


b.

Attach the 2 clamps and connect the No. 4 exhaust gas temperature sensor to the sensor bracket.


c.

Connect the connector to the No. 4 exhaust gas temperature sensor.