Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › UREA INJECTOR › 2015.06–2017.08
RM27T0E _51 Engine / Hybrid System _053675 1GD-FTV EMISSION CONTROL _0260629 UREA INJECTOR A

1GD-FTV EMISSION CONTROL  UREA INJECTOR  REMOVAL  


PROCEDURE

Hide 77840 1.DISCONNECT UREA TUBE WITH HEATER ASSEMBLY

NOTICE:

Check for dirt or mud on the urea injector set and around the urea tube connector before disconnection. Clean if necessary.


a.

Disconnect the urea tube with heater assembly from the urea injector set.

i.
A356542

Pinch the retainer of the urea tube connector, and then pull the urea tube connector off of the urea tube with heater assembly.

Text in Illustration
V100135

Pinch
V100136

Pull

NOTICE:
·

If there is any solidified urea solution (white solids) on the connection area, clean the solids off with a damp cloth, etc., before disconnecting the connector.

·

Be sure to disconnect the urea tube connector by hand.

·

Check for foreign matter in the urea injector set and around the urea tube connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the urea injector set and urea tube connector.

·

Put the urea injector set and urea tube connector ends in plastic bags to prevent damage and foreign matter contamination.





Hide 23203 2.REMOVE UREA INJECTOR SET

a.
A352187

Disconnect the connector from the urea injector set.


b.
A352188

Remove the 2 nuts and urea injector set and gasket from the front exhaust pipe assembly.