Home › Engine / Hybrid System › 5L-E (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM27T0E _51 Engine / Hybrid System _053677 5L-E INTAKE / EXHAUST _0260638 INTAKE MANIFOLD A

5L-E INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 17130 1.REMOVE INTAKE PIPE

a.
U169287

Loosen the hose clamp and remove the 2 bolts and intake pipe.


Hide 17114A 2.REMOVE INTAKE FLANGE

a.
A224307

Remove the bolt and disconnect the PCV hose and heater hose bracket.


b.
A224306

Disconnect the manifold absolute pressure sensor connector.


c.
A224831

Remove the 3 nuts, intake flange and gasket.


Hide 26100G 3.REMOVE DIESEL THROTTLE BODY ASSEMBLY

a.
A224308

Disconnect the throttle open switch connector.


b.

Remove the 2 bolts and disconnect the wire harness bracket.


c.
U169076

Disconnect the throttle control motor connector.


d.

Remove the diesel throttle body and gasket.


Hide 4.REMOVE INJECTION PIPE

a.
A121940

Using a 17 mm union nut wrench, loosen the 8 union nuts of the 4 injection pipes.


b.

Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes together with the 2 lower pipe clamps.


Hide 17111 5.REMOVE INTAKE MANIFOLD

a.
A224309

Remove the bolt and disconnect the wire harness bracket.


b.
A224310

Remove the 6 bolts, 2 nuts, intake manifold and gasket.