Home › Engine / Hybrid System › 1GD-FTV (INTAKE / EXHAUST) › INTAKE MANIFOLD › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053680 1GD-FTV INTAKE / EXHAUST _0260654 INTAKE MANIFOLD G

1GD-FTV INTAKE / EXHAUST  INTAKE MANIFOLD  INSPECTION  


PROCEDURE

Hide 17111 1.INSPECT INTAKE MANIFOLD

A359725

NOTICE:

Do not adjust the adjusting screw or 2 actuator installation bolts.


a.
A359726

Check the operation of the swirl control valve.

i.

Check that the valve is fully opened under normal conditions.


ii.

Connect a vacuum pump to the control valve. Check that the valve is fully closed when a negative pressure of 66.7 kPa (500 mmHg, 19 in.Hg) is applied.


iii.

Leave it for 1 minute and check that the vacuum pump needle does not move. If the result is not as specified, replace the intake manifold.



Hide 2.INSPECT VACUUM SWITCHING VALVE

a.

Measure the resistance according to the value(s) in the table below.

Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 33 to 39 Ω
1 - Body ground
2 - Body ground
20°C (68°F) 10 kΩ or higher

If the result is not as specified, replace the intake manifold.


b.
G037162E10
2.542,1.083 2.958,0.854 false 0.885,0.667 1.563,1.177 false 0.677,0.563 0.885,0.708 0.208,0.146 10 false *a 2.979,0.75 3.333,0.896 0.354,0.146 10 false *b

Text in Illustration
*a Port E
*b Filter
V100135

Airflow

Check the operation according to the value(s) in the table below.

i.

Check that air flows from port E to the filter. If the result is not as specified, replace the intake manifold.


ii.
A110309E10
1.9,0.535 2.012,0.679 0.112,0.144 10 2 2.128,0.772 2.235,0.917 0.107,0.145 10 1 1.863,0.621 1.772,0.621 1.772,0.621 1.489,1.396 false 2.099,0.859 2.007,0.859 2.007,0.859 1.575,1.462 false 1.064,1.533 1.229,1.678 0.165,0.145 10 *a 1.061,1.618 0.969,1.618 0.969,1.618 0.823,1.728 false 0.06,1.718 0.225,1.863 0.165,0.145 10 *b 0.241,1.806 0.333,1.806 0.333,1.806 0.507,1.876 false

Text in Illustration
*a Port E
*b Port F
V100135

Airflow

Apply battery voltage across the terminals.


iii.

Check that air flows from port E to port F. If the result is not as specified, replace the intake manifold.