Home › Engine / Hybrid System › 1GD-FTV (INTAKE / EXHAUST) › EXHAUST MANIFOLD W/ TURBOCHARGER
RM27T0E _51 Engine / Hybrid System _053680 1GD-FTV INTAKE / EXHAUST _0260655 EXHAUST MANIFOLD W/ TURBOCHARGER L

1GD-FTV INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER  PRECAUTION  


MAINTENANCE PRECAUTION


a.
A344972

Pay due attention when removing and reinstalling the turbocharger sub-assembly. Do not drop, strike, or grasp easily-deformed assembly parts.

NOTICE:
·

Do not hold the actuator or control rod.

·
A344973

When storing the turbocharger subassembly, do not store the assembly with the actuator facing down.

·

Make sure foreign matter does not enter the intake and exhaust ports and oil passage.




b.
A345123E01
0.414,1.24 0.681,1.498 0.267,0.258 10 *1 0.397,0.198 0.664,0.455 0.267,0.258 10 *a 0.604,1.315 1.165,1.315 false 0.609,0.306 0.901,0.306 false 0.901,0.306 1.463,0.839 false

Text in Illustration
*1 Oil Inlet Pipe Sub-assembly
*a Sludge

If replacing the turbocharger sub-assembly, check for deposits in the turbo oil inlet pipe subassembly.

If necessary, replace the turbo oil inlet pipe subassembly.


c.

Thoroughly remove any old gasket material sticking to the lubrication oil pipe flange or turbocharger sub-assembly oil flange.


d.

If replacing the bolts or nuts, use TOYOTA genuine parts to prevent breakage or deformation.


e.
A344971E01
0.85,0.37 1.028,0.37 false 1.028,0.37 1.612,1.132 false 0.661,0.264 0.916,0.475 0.255,0.211 10 *a

Text in Illustration
*a Turbocharger Sub-assembly Oil Inlet Hole

If replacing the turbocharger sub-assembly, add 20 cc (1.2 cu. in.) of fresh oil into the turbocharger sub-assembly oil inlet hole and turn the turbine wheel by hand to spread oil over the bearing.


f.

If overhauling or replacing the engine, cut the fuel supply after reassembly and crank the engine for 30 seconds to distribute oil throughout the engine. Then reconnect the fuel supply and allow the engine to idle for 60 seconds.


g.

Since the turbine wheel runs at an extremely high speed, if the engine is running without the air cleaner, air cleaner cap and hose, the turbine wheel will be damaged due to the entry of foreign particles.