Home › Engine / Hybrid System › 1KD-FTV (COOLING) › RADIATOR › 2015.06–2020.08
RM27T0E _51 Engine / Hybrid System _053682 1KD-FTV COOLING _0260664 RADIATOR G

1KD-FTV COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16401A 1.CHECK RADIATOR RESERVOIR CAP SUB-ASSEMBLY

a.
A112200

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.


ii.

Check that O-ring 1 is not deformed, cracked or swollen.


iii.

Apply engine coolant to O-ring 1 and rubber packing 2 before using a radiator cap tester.


iv.
A110393E21
0.365,1.146 0.594,0.115 0.594,0.115 0.667,0.115 false 1.583,1.052 1.688,0.51 1.688,0.51 1.771,0.51 false 1.813,0.417 2,0.604 0.188,0.188 10 false *2 0.719,0.042 0.896,0.229 0.177,0.188 10 false *1 0.698,2.125 0.885,2.333 0.188,0.208 10 false *a

When using the cap tester, tilt it more than 30°.

Text in Illustration
*1 Radiator Cap
*2 Radiator Cap Tester
*a More than 30°


v.

Pump the cap tester several times, and check the maximum pressure*.

Pump speed:

1 pump per second


*: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Judgment Criterion:
Item Specified Condition
Standard value
(for brand-new cap)
93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi)
Minimum standard value
(after using cap)
79 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap sub-assembly.



Hide 16400 2.INSPECT FINS FOR BLOCKAGE

A112201

a.

If the fins are clogged, wash them with water or a steam cleaner and dry them with compressed air.

NOTICE:
·

To avoid damaging the fins, the injection direction should be at right angles to the core surface.

·

If the steam cleaner is too close to the core, there is a possibility of damaging the fins, so maintain the following injection distances.

Standard Injection Distance:
Injection Pressure Specified Condition
2942 to 4903 kPa
(30.0 to 50.0 kgf/cm2, 427 to 711 psi)
300 mm (11.8 in.)
4903 to 7845 kPa
(50.0 to 80.0 kgf/cm2, 711 to 1138 psi)
500 mm (19.7 in.)


·

If the fins are bent, straighten them with a screwdriver or pliers.

·

Do not expose electronic components to water.




b.

Dry the fins with compressed air.