Home › Engine / Hybrid System › 2TR-FE (LUBRICATION) › LUBRICATION SYSTEM
RM27T0E _51 Engine / Hybrid System _053686 2TR-FE LUBRICATION _0260681 LUBRICATION SYSTEM G

2TR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE OIL LEVEL

a.

Warm up the engine, stop the engine and wait 5 minutes.


b.

Check that the oil level is between the dipstick low level mark and full level mark.

If the level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.



Hide 2.INSPECT ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the engine oil and oil filter sub-assembly (See page Engine / Hybrid System>2TR-FE (LUBRICATION)>OIL AND OIL FILTER>REPLACEMENT).


Hide 3.INSPECT OIL PRESSURE

a.

Remove the engine oil pressure switch assembly (See page Engine / Hybrid System>2TR-FE (LUBRICATION)>OIL PRESSURE SWITCH>REMOVAL).


b.
U166717E02
0.417,1.167 0.521,1.167 0.521,1.167 0.813,0.594 true 0.208,1.073 0.417,1.281 0.208,0.208 10 false *a

Install an oil pressure gauge.

Text in Illustration
*a Oil Pressure Gauge


c.

Warm up the engine.


d.

Measure the oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idle 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi)


If the result is not as specified, check the quality of the engine oil and check the oil paths for clogging.

Repair or replace if necessary. If the oil pressure is still not as specified, check the oil pump (See page Engine / Hybrid System>2TR-FE (LUBRICATION)>OIL PUMP>INSPECTION).


e.

Remove the oil pressure gauge.


f.

Install the engine oil pressure switch assembly (See page Engine / Hybrid System>2TR-FE (LUBRICATION)>OIL PRESSURE SWITCH>INSTALLATION).