Home › Engine / Hybrid System › 1GR-FE (LUBRICATION) › LUBRICATION SYSTEM
RM27T0E _51 Engine / Hybrid System _053687 1GR-FE LUBRICATION _0260686 LUBRICATION SYSTEM G

1GR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloring or thinning.

If the quality is visibly poor, replace the oil and oil filter element (See page Engine / Hybrid System>1GR-FE (LUBRICATION)>OIL AND OIL FILTER>REPLACEMENT).


Hide 2.CHECK ENGINE OIL LEVEL

a.

Warm up the engine, and then stop the engine and wait for 5 minutes.


b.

Check that the engine oil level is between the low level and full level marks on the dipstick.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not fill engine oil above the full level mark.



Hide 3.INSPECT OIL PRESSURE

a.

b.
A222096E08
2.208,0.146 2.396,0.146 2.396,0.146 2.74,0.427 true 2,0.073 2.208,0.25 0.208,0.177 10 true *1

Install an oil pressure gauge.

Text in Illustration
*1 Oil Pressure Gauge


c.

Warm up the engine.


d.

Inspect the oil pressure.

Standard Oil Pressure:
Condition Specified Condition
Idling 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 294 to 588 kPa (3.0 to 6.0 kgf/cm2, 43 to 85 psi)


If the pressure is not as specified, check the oil pump (See page Engine / Hybrid System>1GR-FE (LUBRICATION)>OIL PUMP>INSPECTION).


e.

Remove the oil pressure gauge.