83530
1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
| *a | Adhesive |
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the oil filter bracket.
Do not start the engine for at least 1 hour after the installation.
Attach the 2 clamps to connect the wire harness.
Connect the 2 connectors.
3.INSPECT FOR OIL LEAK
51450
4.INSTALL REAR ENGINE UNDER COVER ASSEMBLY