Home › Engine / Hybrid System › 1GD-FTV (LUBRICATION) › OIL LEVEL SENSOR › 2015.06–2016.08
RM27T0E _51 Engine / Hybrid System _053690 1GD-FTV LUBRICATION _0260708 OIL LEVEL SENSOR G

1GD-FTV LUBRICATION  OIL LEVEL SENSOR  INSPECTION  


PROCEDURE

Hide 89491 1.INSPECT ENGINE OIL LEVEL SENSOR

a.
A362883C01
0.052,0.094 0.292,0.25 0.24,0.156 10 false *a 2.333,2.063 2.563,2.24 0.229,0.177 10 false *b 2.333,2.583 2.563,2.76 0.229,0.177 10 true *c
*a Component without harness connected
(Engine Oil Level Sensor)
*b On
*c Off


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - 2 On at below 40°C Below 1 Ω
Off at below 40°C Below 1 Ω
On at 60°C or higher Below 1 Ω
Off at 60°C or higher 10 kΩ or higher


CAUTION:
·

Do not put your hands in the water warmed up during the inspection.

·

Touching the hot water may result in burns.



NOTICE:

When checking the engine oil level sensor in water, do not allow water to contact the terminals. After completing the check, dry the engine oil level sensor.


HINT:
·

In addition to a level switch, the oil level sensor also has a temperature switch. Therefore, make sure to check the oil level sensor at both high and low temperatures.

·

If the result is not as specified, replace the engine oil level sensor.